TOOL PRODUCTS COMPANY INC.

                                                   

                                                                                                 

INCH AND METRIC DIAL CALIPERS                                6"      $ 29.95 ea.

 
- Stainless Steel fully hardened frame - Shock Proof.
- 4-way measurement: inside, outside, depth and step.
- Single revolution dial graduated 0 -100 with .100" per revolution.
- Reading 1/1,000" - with thumb roll and lock screw.
- Measuring faces hardened, ground and lapped.
- Covered rack - Open Cover - Each piece fitted in a plastic box.

 

 

 

 

                                                         

 

 

ELECTRONIC DIGITAL MICROMETER                                       $ 88.95 ea.

 
- Inch / Metric reading with resolution .0001" X 0.001 mm.
- Zero setting at any point along the spindle.
- Clear easy to read LCD display with data output.
- Automatic power off.
- Serial data output port for interface with computer / printer.
- Enameled cast frame, a carbide tipped, ratchet stop, lock lever.
- Each piece fitted in a wooden box with operating manual and adjusting tool.

 

 

 

                                                  

ELECTRONIC CALIPERS - THREE BUTTONS                6"      $ 37.90 ea.

 
- On / Off button - floating zero button for easy direct reading of relative
  measurements.
- Inch / metric conversion or reading at the switch of a button.
- 4 way measurement with resolution / repeatability .0005" X 0.01 mm. 
- LCD displays 5 digits, no display of invalid zeroes.
- Serial data output port for interface with computer / printer.
- Fitted in plastic box.

 

 

 

 

 

 

                                                               

 

 

 

OUTSIDE MICROMETER                                                                 $ 22.50 ea.

 
- Satin chrome frame with insulating sleeves.
- Carbide tipped faces.
- Ratchet stop - lock lever.
- Clear graduation on satin chrome finish thimble.
- 1 - 2" and larger supplied with calibrating gage.
- Each piece fitted in a box with instructions and zero adjusting key.

 

 

 

Products Guide

Any questions or comments about this web site may be sent by Send Mail to Philip Tolbert

Copyright © 2010 Tool Products Co., Inc.